
Polk Audio · Subwoofers
Polk PSW10
Quick answer
A long-running budget 10-inch sub with a 50 W RMS amp and speaker-level inputs that adds basic bass to small rooms and older stereo setups.
Polk PSW10 Specs
| Driver | 10-inch |
|---|---|
| Amplifier | 50 W RMS / 100 W peak |
| Enclosure | Front-firing, ported |
| Inputs | Line-level RCA and speaker-level |
BHTR Score: 64/100
Our score weighs the spec sheet, the price band and what owners report over time. See how we score.
Our Verdict
The PSW10 is the classic entry-level sub: a 10-inch driver with a 50 W RMS (100 W peak) amp. It has both line-level and speaker-level inputs, so it works with a modern receiver or an older stereo amp without a sub output.
The maths explains its limits. Compared with a 200 W sub such as the Klipsch R-120SW, the PSW10 has 10 × log10(200 ÷ 50) = 6 dB less amp headroom. Its 10-inch cone also has about (10 ÷ 12)² = 0.69× the area of a 12-inch, roughly 3 dB less output at the same cone travel. Add those up and the gap at high levels is large.
Room maths: a 10 × 12 ft room with an 8 ft ceiling is 960 cu ft. As a rough guide, the PSW10 suits small rooms, bedrooms and offices under about 1,000 cu ft, played at moderate levels. In a bigger room, it runs out of steam first on deep movie effects, because each octave lower needs four times the cone movement for the same level.
Set a higher crossover only if your speakers are very small; otherwise 80 Hz is right. If your budget can stretch, the Dayton Audio Classic CS1200 adds a 12-inch driver and a 200 W amp against the PSW10's 50 W RMS. See our best budget subwoofer for home theater guide.
Pros
- Very low price
- Line-level and speaker-level inputs
- Small enough for bedrooms and offices
Cons
- 50 W RMS amp limits output
- 10-inch driver with modest deep-bass reach
- Older design than newer budget rivals
Alternatives to the Polk PSW10
Higher-scoring options
Compare the Polk PSW10
Polk PSW10 FAQ
Is the Polk PSW10 good enough for home theater?
For a small room under about 1,000 cubic feet at moderate volume, it adds useful bass. In larger rooms or at movie levels, its 50 W amp and 10-inch driver run out of headroom quickly.
Can I connect the Polk PSW10 to a stereo amp?
Yes. It has speaker-level inputs, so you can wire it from an amplifier's speaker terminals if the amp has no subwoofer output.
Is the Polk PSW10 worth it?
A long-running budget 10-inch sub with a 50 W RMS amp and speaker-level inputs that adds basic bass to small rooms and older stereo setups. It scores 64/100 on our BHTR Score, ranking #22 of the 22 subwoofers we track. It is best for small rooms and older stereo systems; skip it if your room is over about 1,000 cubic feet or you want movie-level bass.
Featured In
- Best Budget Subwoofer for Home Theater (Best for Small Rooms on a Tiny Budget)